1, Wire Cutting Machine With Standard Edm Introduction
EDM wire cut machine enjoys good reflection from the customers. Its body is the use of high-strength cast iron forming the base for the machine load-bearing parts. Integral structure, its body is used resin casting technology casting (walking wire on the use of this technology).It is a processing equipment that uses the principle of electric discharge to precisely cut various materials.
2,Wire Cutting Machine With Standard Edm Parameter (Specification)
Type |
DK-77100 |
Size of worktable(mm) |
1777*1118 |
Table travel(mm) |
1000*1300 |
Max.workpiece thickness(mm) |
800 |
Max taper angle(°) |
F≤6 G≤60 |
Diameter of molybdenum wire(mm) |
Φ0.10-Φ0.25 |
Power supply(Hz/V) |
50Hz/220V±10% 50Hz/380V±10% |
Drive of worktable |
10 pats 5 phase driven by stepmotor |
Single pulse machining accuracy(mm) |
≤0.001 |
General machining accuracy(mm) |
+-0.01 |
machining speed(mm²/min) |
80-120 |
Optimal surfing roughness(μm) |
Ra≤2.5 |
Overall power(kw) |
<3 |
Weight of machine(kg) |
6700 |
Max.weight of workpiece(kg) |
4000 |
Machine tool outer diam.size(mm) |
3200*3200*3000 |
3, Wire Cutting Machine With Standard Edm Feature And Application
It owns the feature & characteristics as follows,
1)automatic cutting tracking real-time retracing and display of machining trace and drawing of contour of workpiece is three dimensional.
2)automatic return of short circuit Power failure protection Automatic recording of machining trajectory Caller recovery
3)arbitrary shutdown End of stage Default program stop
4)check the content of any segment Modifiable Insert delete any program segment
5)automatic return of short circuit Power failure protection Automatic recording of machining trajectory Caller recovery
6)broken wire treatment: Automatic fault detection fuction of the system Automatic interruption of broken wire Go back to the cut point